06.03
2.13 ADI4 (analog drive interface for 4 axes) (SW 09.01 and higher)
2-106
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Designation Order No. (MLFB)
ADI4 6FC5 211-0BA01-0AA1
The interface module ADI4 is suitable for operating up to four drives with an
analog setpoint interface on the PROFIBUS DP.
The module has the following important features:
S PROFIBUS DP connection (max. 12 Mbit/s), in accordance with:
PROFIDrive profile drive technology version 3,
Draft V1.4.2, 01. September 00
S Four servo interfaces each with one:
– Input: TTL/SSI encoder for incremental and absolute measuring systems
– Output $10V analog
S General and drive-specific digital input/output signals
S On-board status display by means of four diagnostic LEDs
To power the module and the digital outputs, an external power supply source
(+24VDC) is required.
Notice
Please observe the following framework conditions for operating the ADI4 DP
slave:
S An ADI4 DP slave can only be operated on an equidistant PROFIBUS DP
(see Subsection 7.3.6, page 7-220).
S An ADI4 DP slave is not a DP standard slave certified as compliant with the
PROFIDrive profile, e.g. the ADI4 DP slave does not support acyclic com-
munication.
Order No.
Features
2 Hardware Descri
tions
To Next Page
Loading...
