Siemens SINUMERIK 840Di - Page 40

06.03
1.5 840Di start-up
1-40
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Menu command Functionality
Parts programs
S Management of parts programs
Menu command File
– New ...
– Open
– Delete
– Exit
Menu command Edit
– Copy
– Insert
– Load
– Unload.
– Select
S Editing parts programs:
– Menu command File > Open
– Double-click with the left mouse
button on the file
Editor Editing files
Start the editor with:
– Menu command File > Open
– Double-click with the left mouse
button on the file
Menu command File
– Open
– Close
– Cut
– Exit
Menu command Edit
– Copy
– Insert
– Load
– Unload.
– Select
Diagnostics
PROFIBUS
Bus Display of bus configuration:
– Baud rate
– Cycle time
– Synchr. portion (T
DX
)
Display of status:
– Configuration
– Bus status
Slaves Display of:
– Slave no. (DP address)
– Assignment
– Active at the bus
– Synchr. with NC
– Number of slots
– Details
1 General on the SINUMERIK 840Di