Siemens SINUMERIK 840Di - Page 41

06.03
1.5 840Di start-up
1-41
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Menu command Functionality
NC/PLC
S NC
– Display of NC status
– “NC Reset”
– “Clear NC memory”
S PLC
– Display of PLC status
– “RUN-P”
– “RUN”
– “STOP”
– “MRES”
S Latency display
– Current value
– Maximum value
– Number of violations
– Oscilloscope
Log Book Display of SINUMERIK 840Di system mes-
sages
J
1 General on the SINUMERIK 840Di