' $ ! $!& #$"&&"! (%& !' $$ !"
Siemens AG ⋅ January 1999
The following does not represent a complete list of all
the safety measures required for the operation of the
equipment (device, module) as certain operating
conditions may necessitate further measures.
During the operation of electric equipĆ
ment, certain parts of the equipment will
always be subject to dangerous voltages.
Improper use can cause serious personal
injury or material damage.
D Before setting up any electrical conĆ
nections, the PE terminal of the
equipment must be correctly earthed.
D All parts of the circuit linked to the
power supply may be subject to danĆ
gerous voltages.
D Equipment (capacitor storage) can still
be subject to dangerous voltages
even after the supply voltage has
been disconnected.
D Open operation of current transĆ
former circuits is not permitted.
D The threshold values specified in this
manual, i.e. operating instructions,
must not be exceeded; this also
applies to testing and commissioning.
D Only competent persons are perĆ
mitted to operate this equipment. In
order to ensure the trouble-free and
safe operation of this equipment, it is
essential that it is properly transĆ
ported, as well as correctly stored,
assembled, operated and maintained.
These instructions cannot provide detailed informaĆ
tion on all product types or cover every conceivable
method of assembly, operation or maintenance.
If you require any further information, or if you experiĆ
ence any problems not dealt with in detail in the sysĆ
tem manual, please contact your local Siemens dealer
for assistance.
are persons who are familiar
with the installation, assembly, commissioning and
operation of the product and who have the relevant
qualifications, such as, e.g.
D Training or instruction, i.e. authorization to switch
electric circuits and devices/systems on and off,
as well as disconnect, earth and mark said equipĆ
ment in accordance with standard safety requireĆ
ments.
D Training or instruction in the maintenance and imĆ
plementation of appropriate safety equipment in
accordance with standard safety requirements.
D First Aid training.
The product is herewith confirmed to comply with the
requirements set out in the Council Directive on the
Approximation of the Laws of the Member States
relating to Electromagnetic Compatibility
(89/336/EEC) and the use of electrical equipment
within certain voltage limits (the Low Voltage DirecĆ
tive 73/23/EEC).
This conformity has been tested by SIEMENS AG in
accordance with article 10 of the Directive which
complies with the basic specifications of EN 50081
and EN 50082 for the EMC Directive and the basic
specifications of EN 60255-6 for the Low Voltage DiĆ
rective.
The device has been developed and manufactured for
industrial use to EMC standards.
The evaluation has been carried out in accordance
with the international standards of the IEC 255 series
and the national standards DIN 57 435 / Part 303
(corresponds to VDE 0435 / Part 303).
To Next Page
Loading...
Need help?
General
