Siemens Siprotec 7SD600 - Page 9

(!% " %"' $%#''#"    )&'! "( %% "# 

C
page
III
Siemens AG ⋅ January 1999
5.4 Configuring the protective functions 5 - 18................................................
5.4.1 Introduction 5-18.....................................................................
5.4.2 Configuring the functional scope of the device - block 00 5 - 19.............................
5.5 Marshalling of binary inputs, binary outputs and displays 5 - 20..............................
5.5.1 Introduction 5-20.....................................................................
5.5.2 Marshalling of the binary inputs - block 61 5 - 22..........................................
5.5.3 Marshalling of signal relay - block 62 5 - 24...............................................
5.5.4 Marshalling of the LEDs - block 63 5 - 26.................................................
5.5.5 Marshalling of the command relays - block 64 5 - 28......................................
     
6.1 Safety measures 6-1.................................................................
6.2 Operating the device 6-1.............................................................
6.2.1 Membrane keypad/Display panel 6 - 1...................................................
6.2.2 Operation with a PC 6-2..............................................................
6.2.3 Prerequisites for operation 6 - 2........................................................
6.2.4 Front view of the device 6 - 3..........................................................
6.3 Setting of function parameters 6 - 4....................................................
6.3.1 Introduction 6-4.....................................................................
6.3.1.1 Procedure for parameterization 6 - 4....................................................
6.3.1.2 Setting date and time 6-6............................................................
6.3.2 Initial display 6-7....................................................................
6.3.3 System and station data - Block 01 6 - 8................................................
6.3.4 Settings for the line differential protection 6 - 10...........................................
6.3.5 Settings for the pilot wire monitoring 6 - 14...............................................
6.3.6 Settings for the remote tripping 6 - 15....................................................
6.3.7 Settings for tripping on receiving remote command 6 - 16..................................
6.4 Events (alarms) 6-17..................................................................
6.4.1 Introduction 6-17.....................................................................
6.4.2 Operational events - Block 81 6 - 19.....................................................
6.4.3 Fault events - Block 82 6 - 22...........................................................
6.4.4 Reading out operational measured values - Block 84 6 - 25.................................
6.5 Operational control capabilities 6 - 26....................................................
6.5.1 Setting date and time 6 - 26............................................................
6.6 Testing and commissioning 6 - 28.......................................................