PROFIBUS DP Communication Module
SIRIUS 3RW44 System Manual
GWA 4NEB 535 2195-02 DS 04
8-47
The following messages can be entered:
Table 8-23: Log list messages - reading events
ID
No.:
Events - Messages Comment
Warnings
324 Temperature sensor overload ± (coming/going event)
325 Temperature sensor open
± (coming/going event)
326 Temperature sensor short
± (coming/going event)
327 Therm. motor model overload
± (coming/going event)
334 Current limit exceeded
± (coming/going event)
335 Current limit undershot
± (coming/going event)
340 Asymmetry recognized
± (coming/going event)
342 Ground fault
± (coming/going event)
Actions
310 Emergency start is active ± (coming/going event)
357 Automatic operating mode + (coming event only)
358 Manual bus operating mode + (coming event only)
359 Manual operation local operating mode + (coming event only)
360 Connection break in manual operating
mode
± (coming/going event)
363 Maximum pointer deleted + (coming event only)
365 Incorrect parameter value + (coming event only)
ID number of the faulty parameter + (coming event only)
366 Parameter changes not permissible
when ON
+ (coming event only)
ID number of the faulty parameter + (coming event only)
368 Parameterization disable CPU/master
active
± (coming/going event)
369 Factory settings restored + (coming event only)
1302 Log list - trippings deleted + (coming event only)
1303 Log list - events deleted + (coming event only)
To Next Page
Loading...
