Siemens SIRIUS 3RW44 - Activating the Field Bus Interface (PROFIBUS DP); Saving Options

Commissioning
SIRIUS 3RW44 System Manual
5-36 GWA 4NEB 535 2195-02 DS 04
5.4.13 Activating the Field Bus Interface (PROFIBUS DP)
For information on activating the field bus interface, please refer to Chapter 8.4
"Activating the PROFIBUS DP Communication Module (Field Bus Interface) and
Setting the Station Address".
Notice
If the parameter "Parameters disabled CPU/Master" is set to "Off" (factory setting), the
parameters set on the soft starter will be overwritten with the values stored in the GSD
data or in the OM when the bus is started. If this is not desired, the parameter must be set
to "On".
Baud rate
5
12,000 kBd
Substitute
select
6
select
Parameters dis-
select
7
change
Off
abled CPU/Master
ESC OK
ESC OK
ESC OK
value
Station address
select
4
change
23
ESC OK
Fieldbus
select
1
change
interface
On
ESC OK
Group diagnosis
select
2
change
Disable
ESC OK
Behavior on
change
3
Sw. subst. value
ESC OK
CPU/master-stop
Status display
select
2
select
Settings
select
3
select
Parameter
select
1
select
set 1
Saving
select
11
select
options
Fieldbus
select
10
select
Display mea-
select
1
select
1
SIEMENS
Menu
3RW44
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
ESC OK
sured value