Siemens SIRIUS 3RW55 - Page 164

Functions
7.18 3RW5 HMI High Feature
SIRIUS 3RW55 soft starter
164 Manual, 08/2018, A5E35630887002A/RS-AB/002
Parameters
Description
Do Control After Logoff
This parameter describes the response after logging off while the motor is running.
Continue with motor control
(factory setting)
3RW5 HMI High Feature is still the master control.
Stop motor and give back control
The motor stops and the 3RW5 HMI High Feature is no longer the master control.
Message display The settings of the messages to show define which messages are displayed as a
pop-up window on the display of the 3RW5 HMI High Feature.
Error
• Do not display
• Display (factory setting)
Warnings
• Do not display
• Display (factory setting)
Operation display Up to 5 different measured values can be selected from a list of measured values.
You will find additional information on measured values in Chapter Monitoring the
measured values of the 3RW55 soft starter with the 3RW5 HMI High Feature
(Page 160).
• Phase current average (%) (factory setting)
• Phase current average (rms) (factory setting)
• Line-to-line voltage U L1-L2 (factory setting)
• Active power PL1..3 (factory setting)
• Power factor L1..3 (factory setting)
Edit function favorites Setting the favorites menu.
• Add
• Delete
Configure start key Setting the start key
• Motor CW (factory setting)
• Motor CW with creep speed
• Motor CCW
• Motor CCW with creep speed
Language The required language is set in the "Language" menu.
• English (factory setting)
• German
• French
• Spanish
• Italian
• Portuguese
• Chinese
• Additional language 1