Siemens SIRIUS 3RW55 - Installing the High Feature 3 RW5 HMI on a Flat Surface

Mounting and dismantling
3.4 Installing / mounting / removing 3RW5 HMI High Feature
SIRIUS 3RW55 soft starter
Manual, 08/2018, A5E35630887002A/RS-AB/002
47
3.4.3
Installing the High Feature 3RW5 HMI on a flat surface
Requirements
● Note the mounting positions, minimum clearances and ambient conditions stated on the
data sheet.
● Disassembled 3RW5 HMI High Feature
● Level surface, e.g. sufficiently strong mounting plate
● 2 correctly implemented bore holes
● 2 cap screws M4 x 12 DIN ISO 7045 to fit the bore holes
● Screwdriver (depending on the drive of the screws)
● Push-in lugs for wall mounting (accessories)
● Connected HMI connecting cable of suitable length (accessories)
Procedure
● Connect the connecting cable of the 3RW5 HMI High Feature to the 3RW55 soft starter.
Pay attention to the coding of the plug and socket.
● Insert the push-in lugs into each side of the enclosure until you hear them engage
① and
fix the 3RW5 HMI High Feature on the wall
② + ③.