Siemens SIRIUS 3RW55 - 9.3 Restoring Factory Setting

Maintenance and service
9.3 Restoring factory setting
SIRIUS 3RW55 soft starter
192 Manual, 08/2018, A5E35630887002A/RS-AB/002
9.3
Restoring factory setting
Effects of the factory setting
The following devices can be reset to the factory setting:
● 3RW5 soft starter
– The parameters of the 3RW5 soft starter are reset to the factory setting (depending on
the 3RW5 soft starter).
– User accounts are deleted (depending on the 3RW5 soft starter).
– An automatic restart of the 3RW5 soft starter is performed.
● 3RW5 communication module
– The parameters of the 3RW5 communication module are reset.
● 3RW5 HMI High Feature
– The parameters of the 3RW5 HMI High Feature and the PIN for access protection are
reset to the factory setting.
● All devices
– The 3RW5 soft starter, the 3RW5 communication module, and the 3RW5 HMI High
Feature are reset to the factory settings, as described above.
Procedure
1. Make sure that the motor is switched off and you do not start the motor while restoring the
factory settings.
Make sure that the main voltage is only applied to the 3RW5 soft starter when it is
necessary.
2. Restore the factory settings.
The following procedures are possible:
– Via the local interface on the 3RW5 HMI High Feature with SIRIUS Soft Starter ES
(TIA Portal)
– With a fieldbus via a 3RW5 communication module (depending on the respective
3RW5 communication module) with SIRIUS Soft Starter ES (TIA Portal) Premium
– With a fieldbus via a 3RW5 communication module (depending on the respective
3RW5 communication module) with the configuration software of the controller
(e.g. STEP 7). Only the communication parameters are reset here.
– Via the 3RW5 HMI High Feature
Restoring the factory settings via High Feature 3RW5 HMI (Page 193)
Restoring the factory settings with the Master RESET button via 3RW5 HMI High
Feature (Page 194)
Result
The factory setting of the selected device or all devices is restored.