Siemens SIRIUS 3RW55 - 6.2 Application Wizard

Commissioning
6.2 Application wizard
SIRIUS 3RW55 soft starter
76 Manual, 08/2018, A5E35630887002A/RS-AB/002
6.2
Application wizard
Operating principle
The application wizard enables easy commissioning by suggesting a suitable selection of
parameters for specific applications. The application wizard can be used for any set of
parameters.
Requirements
● Access protection to the 3RW5 HMI High Feature is not active or has been reset.
● You are in menu "Parameters > Soft Starter > Application wizard"
Procedure
1. You receive a list that is reduced to the relevant parameters.
All parameters that are not displayed remain unchanged.
2. Select the parameters that you would like to adapt.
Alternatively, activate the "Start automatic parameterization" function. In this case, the
recommended parameters of the selected application are automatically accepted as the
start value for the automatic parameterization: For the PRESET starting time the ramp-up
time is adopted as the start value and, for the current limiting, the preset value of the
application. Then adjust the rated operational current I
e
of the motor connected to the soft
starter.
Result
The parameterization has been performed for the selected application. You can make
changes to parameters at any time in the "Parameters" menu.