Engineering and remote access
7.8 OPC UA server
Power supply system SITOP PSU8600
342 Manual, 09.2018, A5E36758446-5-76
The parameters for the battery modules are listed under the "SubDevices" nodes.
SITOP BAT8600 battery modules
ActualState
ModuleOperatingState Enumeration MultiStateDiscrete-
Battery status
ModuleStateOfHealth Integer AnalogItemType State of health of the battery mo-
dule
Capacity of the battery module
Total operating time of the batteries
ModuleStateLed Object Sitop_8600_LedType Actual state of the LED display
Alarm_MR_BatteryCommunication
Disconnected
Boolean PropertyType Communication to the battery is
interrupted. Buffering is still possi-
ble, the battery charge level has
been reduced to a minimum how-
Alarm_MD_BatteryDefect Boolean PropertyType Battery defective - neither buffer
nor charging operation is possible
Alarm_MD_BatteryParameters
Boolean PropertyType The battery configuration is corrupt.
Battery behavior may deviate.
Alarm_MD_BatteryTemperature
HighError
Boolean PropertyType Battery temperature is too high and
the battery was shut down for safe-
ty reasons. Buffering is no longer
possible depending on the number
Alarm_MD_BatteryTemperature
LowError
Boolean PropertyType The battery temperature is too low.
The battery will not operate in this
situation. Buffering is no longer
possible depending on the number
Alarm_MD_IncompatibleBatteryDe-
tected
Boolean PropertyType The battery is a type that is not
compatible with the configuration.
The battery cannot be commis-
Alarm_MD_LessCapableBattery
Detected
Boolean PropertyType A module with reduced power was
detected. Deviating system beha-
Alarm_MR_BatteryDeepDischarge Boolean PropertyType Battery is deep discharged - no