To Next PageTo Next PageWhy did Siemens Power Supply shut down due to phase failure or unbalanced supply voltage?
If your Siemens Power Supply system shuts down due to phase failure or unbalanced supply voltage, it is because operation has continued for an impermissibly long duration under these conditions. As a result, all outputs of the power supply system have been switched off.
Why did my Siemens Power Supply shut down due to impermissible supply voltage?
If the Siemens Power Supply unit shuts down because of an impermissible supply voltage, it means the supply voltage is outside the permissible limits. Consequently, the outputs of the power supply system have been switched off.
What does invalid number of modules mean for Siemens SITOP PSU8600?
Invalid slot.
What causes overload shutdown of the output in Siemens Power Supply?
An overload shutdown of the output in Siemens Power Supply occurs because of an inadmissible overload at the output. Consequently, the output was shut down.
What happens when Siemens SITOP PSU8600 Power Supply has unclassified hardware fault?
When the Siemens Power Supply experiences an unclassified hardware fault, all outputs of the power supply system have been switched off.
What does invalid parameter value transferred mean for Siemens SITOP PSU8600?
An invalid parameter value transferred for Siemens Power Supply indicates an invalid parameter.
What causes invalid parameter error on Siemens Power Supply?
The invalid parameter error on Siemens Power Supply is caused by a faulty parameter.
How can Siemens SITOP PSU8600 be switched on after shutdown?
The Siemens Power Supply can be reset by switching the supply voltage off and on.
How to fix incorrect checksum on Siemens SITOP PSU8600 Power Supply?
Defective firmware has been detected. Reactivate the Siemens Power Supply with a new firmware update.
Why is Siemens Power Supply showing invalid internal supply voltage?
The Siemens Power Supply shows an invalid internal supply voltage because the voltage of the internal supply is too high. Consequently, all outputs of the power supply system have been switched off.
General| Output Voltage | 24 V DC |
|---|---|
| Protection Features | Overload, short-circuit, overvoltage, overtemperature |
| Mounting Type | DIN Rail |
| Output Current | 40 A |
| Operating Temperature | -25 to +70 °C |
| Communication | Ethernet, PROFINET |
