Siemens ULTRAMAT 23 Series - The PUMP Key

7.4.3.5 The PUMP key
If the analyzer is equipped with an internal sample gas pump, this can be switched on and o󹪜
using the <PUMP> key. If the pump is switched o󹪜 while the analyzer is in input mode, it is also
switched on again by pressing the <MEAS> key if parameterized accordingly
(see Con󹪝guration: Inputs/outputs/pump: Pump at CAL/MEAS (Page 144)).
In addition to use of the <PUMP> key, the pump can also be switched on and o󹪜 via the binary
input. The binary input has priority over the key.
Operation
7.4 Operating modes
ULTRAMAT 23
100 Equipment Manual, 04/2022, A5E37100388-012