Note
Energy saving
The display brightness is reduced after approx. 30 minutes without an operation. This serves for
energy saving and has no inuence on the other properties of the device.
The display becomes bright again when you continue with operation.
Inputs and outputs
• Three binary inputs for switching the sample gas pump on and o, triggering of AUTOCAL,
and synchronization of several devices.
• Eight freely-congurable relay outputs for faults, maintenance requests, maintenance
switches, limits, measuring range identications, and external solenoid valves.
• Analog outputs for each component electrically isolated from analyzer ground.
• Optional: 8 additional relay outputs.
• Optional: 8 additional binary inputs.
Communication
ELAN (RS485) present in basic unit.
Options:
• RS485/USB converter
• RS485/RS232 converter
• RS485/Ethernet converter
• Incorporation in networks via PROFIBUS DP/PA interface (via option board)
• SIPROM GA software as servicing and maintenance tool, also applicable for continuous
digital data acquisition
3.3 Function
Several independent measuring principles which work selectively may be present in the
ULTRAMAT 23. These are described below.
Description
3.3 Function
ULTRAMAT 23
24 Equipment Manual, 04/2022, A5E37100388-012
To Next Page
Loading...
