Siemens ULTRAMAT 23 Series - Parameters: Pump;Lcd Contrast: Pump; Parameters: Pump;Lcd Contrast: LCD Contrast; Configuration

8.3.5.1 Parameters: Pump/LCD contrast: Pump
Pump/flow o.k.
˅ + >: to adjust
ENTER: Save new val.
ESC: Keep new val.
8341
In this menu you can:
• Increase the pump capacity using the <→> or <↑> key
• Decrease the pump capacity using the <↓> key
• Store the set pump capacity using the <ENTER> key
• Cancel the input using the <ESC> key.
Changes to the pump capacity are shown on the 󹪞owmeter and
directly in the menu display by the message "o.k." or "not o.k.".
8.3.5.2 Parameters: Pump/LCD contrast: LCD contrast
LCD contrast
˅ + >: to adjust
ENTER: Save new val.
ESC: Keep new val.
8342
In this menu you can:
• Increase the contrast using the <→> or <↑> key. This darkens
the characters.
• Decrease the contrast using the <↓> key. This brightens the
characters.
• Store the set contrast using the <ENTER> key
• Cancel the input using the <ESC> key.
Note
Simultaneous pressing of the three keys <↑> , <↓> and <→> sets an average contrast again.
8.4 Con󹪝guration
With this function group you can assign relays and inputs/outputs and use special functions and
test functions. The following 󹪝gure shows the associated menu sequence, further menu
sequences are shown under '842' and '843'. An explanation of the display elements can be found
in section Input mode (Page 95)).
Access to the "Con󹪝guration" menu is protected by code level 2.
Functions
8.4 Con󹪝guration
ULTRAMAT 23
Equipment Manual, 04/2022, A5E37100388-012 133