Siemens ULTRAMAT 23 Series - Page 134

)XQFWLRQVIRU
6,(0(16VHUYLFH
Inputs/outputs/pump
Special functions
Tests
Factory config.
Sync input
Binary inputs
Function ctrl 1 : X
Function ctrl 2 : X
Function ctrl 3 : X
Function ctrl 4 : X
Fault/MaintenanceReq
Function control
Measuring ranges
Clear logbook
Relays for limits
Relays for MR
Relays for status
Relays for valves
External valves
Zero gas : relay -
Span gas : relay -
Sync : relay -
Mode of
Sync input
:activate CAL relay
Analog outputs
Assign relays
Binary/Sync inputs
Pump ON/OFF modes
NNNNN MR1 : X
NNNNN MR2 : X
NNNNN MR AR: X
Level 2 required
Fault 5 : X
Fault 6 : X
Fault 7 : X
External faults 1-4
External faults 5-7
Ext. maint. req. 1-4
Ext. maint. req. 5-7
Clear logbook: XX
Pump at CAL : ON
Pump at MEAS: ON
Optional board not
found!
Return with ESC
Analog output ranges
Output during FCTRL
Output during faults
Analog output
Set value:
Range: 4 / 20 mA
Meas. value neg: ON
Analog output during
Function control
Meas. value: Actual
Analog output
during faults
Meas. value: ZERO
Select component
Relays NNNNN limits
Limit 1: relay -
Limit 2: relay -
Fault :R-
MaintenanceReq.:R-
CAL/MEAS :R-
FunctionControl:R-
NNNNN MR relay -
NNNNN MR relay -
NNNNN MR relay
NNNNN MR relay -
Select component
Fault 1 : X
Fault 2 : X
Fault 3 : X
Fault 4 : X
Maintenance Req.5 : X
Maintenance Req.6 : X
Maintenance Req.7 : X
Maintenance Req.1 : X
Maintenance Req.2 : X
Maintenance Req.3 : X
Maintenance Req.4 : X
84
8413
841322
84132
8412
84124
84131
841
841321
841324
8414
84132a
8411
84111
84112
84113
84121
84123
84122
843
842
841323
8413212
8413213
8413214
8413211
The special functions (menu display 842) are described in section Con󹪝guration: Special
functions (Page 144), the analyzer tests (menu display 843) in section Con󹪝guration: Device test
(Page 153).
Functions
8.4 Con󹪝guration
ULTRAMAT 23
134 Equipment Manual, 04/2022, A5E37100388-012