Siemens ULTRAMAT 23 Series - Parameter: Measuring Ranges

83
Measuring ranges
Limit values
Time constants
Pump /LCD contrast
Switch range NNNNN
Actual range: AR
MR 1.0..XXXXX mg/m
MR 2.0..xxxxx mg/m
832
Limit 1 NNNNN
Limit 2 NNNNN
Protec. sensor H2S*
833
Time constants NNNNN
T90 within : XX.X s
T90 outside: XX.X s
Threshold : XX.X %
834
Adjust pump / flow
Adjust LCD contrast
8312
Change range NNNNN
MR 1.0..XXXXX mg/m
MR 2.0..xxxxx mg/m
8313
Limit 1 NNNNN
Lim. 1: XXXXX mg/m
Alarm conc. :-----
8321
8322
Select component
Switch ranges NNNNN
Change ranges NNNNN
Hysteresis NNNNN
831
Pump/flow o.k.
˃ + ˅: adjust
ENTER: save new val.
ESC: keep old val.
8341
Level 1 required
3
3
8311
3
3
Hysteresis AUTORANGE
MR1 XXXXX mg/m NNNNN
MR1->MR2: XXX.X% MR1
MR2->MR1: XXX.X% MR1
3
Adjust LCD contrast
˃ + ˅: adjust
ENTER: save new val.
ESC: keep old val.
8342
Select component
3
Limit 2 NNNNN
Lim. 2: XXXXX mg/m
Alarm conc. :-----
3
Select component
* valid only for H2S
8323
Protec. sensor H2S:
XXX*
8.3.1 Parameter: Measuring ranges
Switch ranges SO2
Change ranges SO2
Hysteresis SO2
831
In this menu you can:
• Permit or cancel the switching over between measuring
ranges
• Set the full-scale values
• De󹪝ne a hysteresis.
Functions
8.3 Parameter
ULTRAMAT 23
Equipment Manual, 04/2022, A5E37100388-012 127