The parameterization of two analyzers for correction of cross-interference is demonstrated
using the following example. Analyzer 1 delivers the measured values, analyzer 2 uses these
values for a correction calculation.
Note
Neither analyzer is capable of measurements during the AUTOCAL. Therefore it may be
necessary to evaluate signals for the function control.
Example of correction of cross-interference of CO
2
on CO with 6 vpm CO at 25% CO
2
via
ELAN
Functions
8.4 Conguration
ULTRAMAT 23
148 Equipment Manual, 04/2022, A5E37100388-012
To Next Page
Loading...
