Part No. Designation Remarks
4 Chopper plate glued 2-channel with threaded rods and windows
5.1 O-Ring for analyzer chamber required for analyzer chamber lengths 20 mm and more
5.2 Analyzer chamber
5.3 Analyzer chamber
7.1,7.2 *
**)
Receiver chamber
8 **) Optical lter with lter support
*) Following replacement of this part, special work is required which can only be carried out by a Siemens certied service center
or by qualied, specially trained personnel, for example temperature compensation, basic electronic adjustment, 3-point
calibration with calibration gas etc.
**) Following replacement of this part, the water vapor cross-sensitivity must be checked.
Spare parts/accessories
13.6 IR analyzer units
ULTRAMAT 23
206 Equipment Manual, 04/2022, A5E37100388-012
To Next Page
Loading...
