Siemens ULTRAMAT 23 Series

To Next Page

To Previous Page

Electrical characteristics

AUTOCAL function Automatic calibration (adjustment) of all channels with ambient air (in case

oxygen is present as measured component) or nitrogen (depending on

measured component), adjustable cycle time from 1 … 24 hours. If 0 hours

is entered, the cycle is deactivated.

AUTOCAL cycle must be activated for certi󹪝ed emission measurements

Options Add-on electronics, with 8 additional digital inputs and 8 additional relay

outputs, for e.g. triggering of automatic calibration, PROFIBUS PA/DP

Climatic conditions

Permissible ambient temperature

• During operation

• During transportation and storage

+5 ... +45 °C (+41 ... +113 °F) (limited when used with H

S sensor,

cf. Hydrogen sul󹪝de sensor (Page 41))

-20 °C ... + 60 °C (-4 ... +140 °F)

Permissible ambient humidity < 90% RH (relative humidity) during transportation and storage (Delivery

information (Page 12))

Permissible ambient pressure 600 ... 1200 hPa (absolute)

Maximum operating altitude 2000 m above sea level

Pollution degree 2

Gas inlet conditions

Sample gas pressure

• Without pump

before device: On the inlet side, the overpressure of the gas with respect to

ambient pressure must not exceed 45 hPa.

after device: On the outlet side, the gas outlet must be depressurized

against ambient pressure.

• With pump

before device: Depressurized suction mode

after device: On the outlet side, the gas outlet must be depressurized

against ambient pressure.

Sample gas 󹪞ow 72 ... 120 l/h (1.2 .. 2 l/min)

Sample gas temperature 0 ... +50 °C (+32 ... +122 °F)

Sample gas humidity < 90% RH (relative humidity), non-condensing

Note

Since measuring ranges can be changed, all accuracy data applies to the ranges speci󹪝ed on the

label!

Siemens ULTRAMAT 23 Series - Page 33