Siemens ULTRAMAT 23 - Configuration: Inputs;Outputs;Pump: Pump at CAL;MEAS; Configuration: Special Functions

Functions
8.4 Configuration
ULTRAMAT 23
142 Manual, 3/2016, A5E37100388-003
The functions are shown in the following table:
Table 8- 5 Overview of binary inputs
Function
Control with
Effect
0 V
24 V
- (vacant)
External fault 1 ... 7 x e.g. signaling of a fault in gas conditioning (cooler, flow, condensation trap,
...)
External maintenance
request 1 ... 7
x e.g. signaling of a maintenance request in gas conditioning (filter, flow, ...)
Function control 1 ... 4
x
e.g. signaling of maintenance
Measuring range 1,2
x
The corresponding range is selected (autoranging OFF)
Autorange
x
Autoranging is switched on
Delete logbook
x
Delete all fault and maintenance request entries
8.4.1.4
Configuration: Inputs/outputs/pump: Pump at CAL/MEAS
You can use th
is menu to define the response of the pump.
The following parameters and values are possible:
•
Pump at CAL
:
Pump switched
ON
or
OFF
during an AUTOCAL
•
Pump at MEAS
:
Pump switched
ON
or
OFF
during measuring mode.
8.4.2
Configuration: Special functions
Following selection of the special functions, the adjacent menu
is displayed with the following options:
•
Change codes
•
Change language
•
Setting of AUTOCAL tolerances
•
Parameterization of interfaces
•
Change physical units in which the measured values are
output
•
Changing the factory settings