Description
3.2 Design
ULTRAMAT 23
22 Manual, 3/2016, A5E37100388-003
● Open interface architecture (ELAN (RS485), PROFIBUS-DP/PA), thus simplified process
integration
● Communication software. SIMATIC PDM and SIPROM GA.
● Remote operation and control (via SIPROM GA and PROFIBUS).
Special benefits when used in biogas plants
● Continuous measurement of all 4 important components, including H
2
S
● Long service life of the H
2
S sensor even at increased concentrations;
no diluting or backflushing necessary
Available as bench-top or rack unit.
80-digit display panel (4 lines with 20 characters each).
Dust-tight and washable membrane keyboard.
Flowmeter for monitoring the sample gas flow.
Gas and electrical connections at the rear.
O
2
sensor (option) can be removed from the front after taking off the cover.
Control and function keys for operation.
Figure 3-2 Design of ULTRAMAT 23 as 19" rack unit
The ULTRAMAT 23 is also available as a bench-top unit. This version differs from the rack
unit shown here as follows:
● Closed housing without mounting frame.
● 2 handles on the sides.
● 4 rubber feet for setting up.
● The bench-top unit is not available with Ex approval.
To Next Page
Loading...
