Functions
8.5 Automatically executed functions
ULTRAMAT 23
Manual, 3/2016, A5E37100388-003
155
Configuration: Factory configuration
Overview
These are factory settings made especially for your analyzer.
Since incorrect modifications to these parameters may perm
a-
nently influence the functions of your analyzer, access to these
functions is only possible by specially trained and a
uthorized
servicing engineers using a special access code.
Automatically executed functions
8.5.1
Probe protection and purging function
A protection and purging function is implemented by means of software since H
2
S
concentrations above the specified continuous concentration impair the functionality and
service life of the H
2
S probes.
In addition, a purging function is implemented for the 50 ppm H
2
S probe in order to allow an
intermittent measurement above the permissible continuous concentration.
These functions are executed automatically when certain operating states occur.
To Next Page
Loading...
