Siemens ULTRAMAT 23 - Page 148

Functions
8.4 Configuration
ULTRAMAT 23
148 Manual, 3/2016, A5E37100388-003
Configuration: Special functions: ELAN/PROFIBUS/external interference: PROFIBUS parameters
You can use this function t
o set the following PROFIBUS pa-
rameters:
•
Address
This function can be used to set a PROFIBUS station
address to all numerical values between 0 and 126.
•
Ident number
This parameter is used to set the configuration response of
the device. The values 0, 1 and 3 can be set as valid
parameters. They have the following meanings:
–
0
:
Only the 'Profile ID number' is positively acknowledged
–
1
:
Only the device-specific 'ID number' is positively
acknowledged.
Note
:
In order to work with the provided GSD and DD, the '
ID
number
' parameter must have the value 1.
–
3
:
Only the 'Profile ID number' for multi-variable devices
(complex analyzers) is positively acknowledged.
•
PB relay
You can use this function to enable the 8 relays of the add-
on card for control via PROFIBUS. To allow activation, none
of these relays must already be occupied by a device-
internal function.
Note
:
The function 'PB relay' is only possible as of PROFIBUS
card firmware version 2.0.0 (shown as Firmware in the
figure).
•
Diagnosis
If the 'Diagnosis' parameter is selected, the 'Firmware'
display appears with, for example, the following parameters:
–
Firmware
The firmware version is displayed here
–
Boot FW
The version of the boot firmware is displayed here
–
TAG
The name assigned to this analyzer in the network (or
the first 16 characters).