The cross is not shown completely until the new change has been
programmed:
. The authorisation cross will not disappear completely
until programming is successfully complete.
NOTE
Changes are shown with yellow borders and are not yet saved. These
changes are not saved during programming.
Accept the changes before programming by clicking the button SAVE .
NOTE
All component changes and authorisations must be programmed (see
Programming components [}27]
) before they actually come into effect.
5.5 Assign time plan
This additional function is optional, so you don't necessarily need to use it.
There are basically two types of time plans:
Weekly: Individual time intervals can be assigned to each day of the
week.
EXAMPLE: The housekeeper only has access on certain days and at
certain times – e.g. Mondays 8 a.m. to noon and Thursdays 1 p.m. to
3.30 p.m.
Daily: A general time zone plan can be created for an entire week.
EXAMPLE: Employee John Dorian is authorised to activate locking
devices between 7a.m. and 7 p.m. from Mon to Fri.
Proceed as follows to assign a time plan to a key:
ü Matrix screen open
1. Click on the required key on the matrix screen.
9 The context menu opens.
MobileKey (Manual)
5. Basic functions
23 / 75
To Next Page
Loading...