Simons Voss Technologies MobileKey - Configure Network; Programming of Components with Online Upgrade

6.6 Configure network
ü At least one SmartBridge has been added.
ü SmartBridge connected to Internet and ready for operation.
ü At least one lock with online chip ID added.
ü The distance between SmartBridge and locking devices is less than
30m.
All components should be within the SmartBridge radio range at
all times!
1. Click on the menu button .
9 Menu opens.
2. Click on the button NETWORK .
3. Click on the button START CONFIGURATION .
9 The MobileKey network is configured fully automatically.
9 The status of SmartBridges and locking devices must be set to "ON-
LINE" when configuration is complete.
Go through the following check list if the automatic configuration was not
successful:
Lock with online upgrade does not work [}67] .
6.7 Programming of components with online upgrade
Programming online locks or online PIN code keypad is also possible via
SmartBridge. Keys or transponders must be programmed using the USB
config device since they do not have a network node (LockNode).
NOTE
Programme each lock or Online PIN Code Keypad before installing it.
NOTE
The access list stored in the locking device is reprogrammed every time
that the device is reprogrammed. Only accesses already imported into the
web app are conserved.
This how you complete programming using the SmartBridge:
ü Chip ID of the lock or online PIN code keypad specified when creating
the lock.
ü SmartBridge successfully configured (see Configure network [}46] ).
ü Matrix screen open
1. Add a component.
2. Assign authorisations if necessary (if you want to change authorisa-
tions).
MobileKey (Manual)
6. MobileKey online upgrade
46 / 75