9 The programming process which then starts automatically is
displayed via the lower message bar.
9 Programming completed.
6.8 Disconnecting components with online upgrade
Online components can be removed from the system again if required.
Warning messages are activated if components are physically removed –
when they are taken outside the MobileKey radio range, for example. You
should therefore always de-register the components concerned in the
system. The de-registration process resets the LockNode. The lock or the
online PIN code keypad retains the configuration and can then only be
accessed via the USB config device until a new online setup is performed.
ü At least one online lock or online PIN code keypad has been created.
ü At least one SmartBridge is created.
1. Click on the menu button .
9 The context menu opens.
2. Click on the button NETWORK .
3. Click on the lock to be disconnected or on the Online PIN code keypad
to be disconnected.
9 Menu opens.
4. Click on the button EDIT .
9 The editing menu of the lock or the PIN code keypad opens.
5. Deactivate the checkbox ONLINE VERSION.
6. Click on the button SAVE .
7. To start the online configuration with the button START CONFIGURA-
TION .
6.9 Carrying out remote opening
ü Locking system configured correctly.
ü SmartBridge connected to the Internet.
ü Remotely opening lock with online extension.
ü Remote lock properly configured (see
Creating a lock with online
upgrade [}41]
).
ü Matrix screen open
1. Click on the locking device you wish to open remotely.
9 Context menu opens.
MobileKey (Manual)
6. MobileKey online upgrade
48 / 75
To Next Page
Loading...