Microsoft Internet Explorer
Mozilla Firefox
Google Chrome
Apple Safari
Opera
You also need to have a permanent internet connection at all times. A
high-speed Internet access is required to work without interruption.
1.1.2 Programming
You can programme the MobileKey locking components with the USB
config device with the following devices:
Windows device
Operating system: Windows Server 7, 8 or 10.
Hardware: USB port to connect the USB config device.
No special hardware configurations are required for programming.
The operating system must be stable and run free of errors.
The current version of Microsoft .NET Framework (at least Version
3.5) must be installed on the computer.
Follow the instructions on programming app installation to programme
the MobileKey locking components.
Android device
You need to install the programming app from the Google Play Store
to use the MobileKey app.
Changes to the locking plan are made in the browser, such as the
MobileKey web app.
The USB config device can be connected directly to the Android
device or using an OTG cable available separately.
The Android device must support the OTG function in such a case. If
you are not sure whether your Android device supports OTG or not,
you can use a suitable app from Google Play to check this function.
Search for "OTG check", for example.
Important: Such apps have nothing to do with SimonsVoss
Technologies GmbH. We therefore accept no liability for any
damages or problems caused by such apps.
Use the MobileKey web app to launch the MobileKey app to
programme the MobileKey locking components.
MobileKey (Manual)
1. Introduction
6 / 75
To Next Page
Loading...