Simons Voss Technologies MobileKey - Read Access Event Log

PIN CODE KEYPADS
Information Meaning
Type
Standard entry without any further
meaning.
Firmware
Firmware of the PIN code keypad
used.
If the PIN code keypad is not pro-
grammed, then --
is displayed.
ChipID
Chip ID of the network node used
(LockNode).
If no LockNode is present, then -- is
displayed.
Status Possible statuses:
Code
Article number of the PIN code
keypad. You can reorder the same
PIN code keypad with this article
number. In the event of technical
problems, you can send this article
number to support for identification.
Alternatively, you can also read out the components (see Read
components [}64] ).
5.10 Read access event log
All access events with a key are logged in the locking device. MobileKey
locks log up to 500 accesses. If further accesses take place afterwards, the
oldest accesses are overwritten. Proceed as follows to display the access
protocol:
ü Matrix screen open
1. Click on the required ready programmed lock to read its log.
9 Menu opens.
MobileKey (Manual)
5. Basic functions
33 / 75