NOTE
SmartBridge connection to server
Your SmartBridge connects to the server approximately every 15 seconds. If
you start the network configuration immediately after setting up the
SmartBridge, the server cannot yet identify the SmartBridge and the net-
work configuration fails.
After setting up the SmartBridge, wait about twenty seconds before
starting the network configuration.
Changing the default password
NOTE
Unauthorised access with standard access data
The standard access data can be viewed freely. Unauthorised persons can-
not change the access authorisations, but they can change the network
configuration. You will then no longer be able to reach the device via the
network and will have to reset it.
Some browsers do not transmit spaces at the beginning of the password.
1. Change the default password.
2. Do not start the password with spaces.
Change the default password of your SmartBridge:
1. Use the OAM tool to determine the IP address of your SmartBridge.
2. Call up the web interface of your SmartBridge with a browser (user
name: SimonsVoss, password: SimonsVoss).
3. Assign a new password.
For detailed information about the OAM tool and your SmartBridge, please
refer to the OAM Tool Manual, the quick guide for your SmartBridge and
the SmartBridge manual.
6.1.3 Deleting SmartBridge
NOTE
The LockNodes in locking devices can only be reset via the connected
SmartBridge. If locking devices are not flagged for deletion, they will retain
their configuration. However, the locking devices can now only be accessed
via a new SmartBridge or the programming device.
This is how you delete your SmartBridge in the web app:
MobileKey (Manual)
6. MobileKey online upgrade
40 / 75
To Next Page
Loading...