Simons Voss Technologies MobileKey - Page 66

 Is the DHCP server configured in such a way that a device is able to
register on the network?
You can also reach the SmartBridge via a Windows PC using the
SimonsVoss OAM tool
. The OAM Tool allows you make additional
settings to SmartBridge, such as assigning a fixed IP address or
configuring the integrated DHCP server settings. You can find the
OAM tool in the software downloads on the SimonsVoss homepage
(
www.simons-voss.com ).
Detailed information on the OAM tool can be found in the OAM tool
manual.
NOTE
Using fixed IP addresses
DHCP is activated by default. The IP address is assigned automatically. Al-
ternatively, you can also assign a fixed IP address.
 If you use a fixed IP address, enter a DNS (Domain Name Service) via
the OAM tool.
 Check whether the chip IDs and MobileKey IDs have been entered
correctly.
 Is the distance between the SmartBridge and lock more than 1.5 m and
less than about 30m?
 Test the set-up if there is a clear linear distance of 3m without any
obstacles.
 Environmental influences, walls, objects and many other factors
have a considerable effect on signal quality. Network coverage up to
about 30m cannot be guaranteed. If necessary, place additional
SmartBridges.
NOTE
Resetting the SmartBridge
The SmartBridge can be reset to the factory settings by means of a hard-
ware reset (see the supplied quick guide or manual).
MobileKey (Manual)
9. Fault rectification
66 / 75