If this step is not possible, the LockNode configuration can only be reset
with the help of a locking device which does not form part of the locking
system. Fit the LockNode temporarily to an unknown locking device for this
purpose. The system signals that the LockNode is reset after a few
seconds:
Locking cylinder: Audible signal (4 beeps)
SmartRelay: Optical signalling by LED. (Ensure the power supply is
correct)
The LockNode can be connected to any SmartBridge again once it has
been reset.
MobileKey (Manual)
9. Fault rectification
68 / 75
To Next Page
Loading...