Simplex 4100 User Manual

22
There are two types of acknowledges for the 4100 system: Global Acknowledge and Individual Acknowledge. Each
acknowledge type operates with the Supervisory Service Condition in the following manner:
• Global Acknowledge – When Global Acknowledge is used on the 4100 system, a single key press of the
<SUPV ACK> key acknowledges all supervisory service changes in the system. If status change information
is required, you may review this data (after a 30-second delay) by pressing the <SUPV ACK> key and reading
the total number of supervisory service changes on the alphanumeric display.
• Individual Acknowledge (For NFPA 72 Proprietary Receiver Requirements) – If a supervisory service
condition has been acknowledged with the <SUPV ACK> key and further unacknowledged conditions remain
in the system, the tone-alert continues to sound and the next status change is shown on the alphanumeric
display. This process repeats until all changes are acknowledged. When this occurs, the tone-alert silences
and the highest priority acknowledge change appears on the display.
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes