Simplex 4100 User Manual

87
2. Press the <ENTER> key on the ENTRY keypad. Then press the <NEXT> key as many times as is required
for the upper line on the display to show the desired card number.
3. Press the <ENTER> key. Then, using the <NEXT> or <PREVIOUS> key to scroll, check voltage/current
readings on the Power Supply/Charger card.
GENERATING TrueAlarm

REPORTS
• Applies only to systems that feature a printer.
To Obtain a TrueAlarm

Status Report
1. Press the <MENU> key on the DISPLAY/ACTION keypad. Then press the <NEXT> key seven times.
2. Press <ENTER>. Then press <NEXT> twice.
3. Press <ENTER>.
• Printer prints out TrueAlarm

Status Report.
To Obtain a TrueAlarm

Service Report
1. Perform Step 1 above. Then press the <ENTER> key once and the <NEXT> key three times.
2. Press <ENTER>.
• Printer prints out TrueAlarm

Service Report.
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes