Simplex 4100U Application Guide

4-1
This chapter contains general guidelines for smoke control installations and interconnections.
Please refer to the applicable installation documents for component installation instructions. These
documents are shipped with the individual components.
All wiring in the Simplex Smoke Control System must comply with the National Electric Code
(NFPA 70), the National Fire Alarm Code (NFPA 72), the appropriate Simplex Field Wiring
diagrams (refer to the “Field Wiring and Interconnection Diagrams” section of this chapter) and
any state or local requirements.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
General Smoke Control Interconnections 4-2
Dedicated Smoke Control System Wiring 4-6
Non-Dedicated Smoke Control System Wiring Diagrams 4-10
Chapter 4
Installing the Smoke Control System
Introduction
In this Chapter

Simplex 4100U Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Power Supply	120/240 VAC, 50/60 Hz
Max Signaling Line Circuits (SLC)	2
Operating Temperature	0°C to 49°C (32°F to 120°F)
Humidity Range	10% to 93% non-condensing
Network Capability	Yes
Communication Protocol	RS-232, RS-485
Battery Backup	24 VDC
NAC Outputs	4
Signaling Line Circuits (SLCs)	2
Power Supply Current	3.0 A
Max Notification Appliance Circuits (NAC)	4
Max Releasing Circuits	4
Max Relay Circuits	4
Communication Ports	RS-232, RS-485