Response
Ú
Note: Not available for NAC-1 autopilot computers. NAC-1 uses the Steering response
settings.
By default the system switches between HI/LO parameter set based on speed (motor boats)
or speed and wind (sail boats). You can however manually select which parameter set that
shall be used.
HI or LO must be selected if no speed input is available.
You can manually fine tune each of the two (HI/LO) parameter sets. Level 4 is default with
parameter values as set by the autotune function. If no autotune is made (not
recommended) the level 4 values are the factory default values.
A low response level reduces the rudder activity and provides a more “loose” steering.
A high response level increases the rudder activity and provides a more “tight” steering. A too
high response level causes the boat to start lazy-s movements.
Automatic steering
Ú
Note: Not available for NAC-1 autopilot computers.
This option displays an overview of all autopilot steering parameters, and you can adjust
parameters if required.
For more details, refer to the separate NSS evo2 Installation manual.
Installation
Ú
Note: Not available for NAC-1 autopilot computers.
Used for autopilot installation and commissioning. See the separate NSS evo2 Installation
manual.
Commissioning
Ú
Note: Only available for NAC-1 autopilot computers.
Used for commissioning the rudder or virtual rudder feedback.
Steering response
Ú
Note: Only available for NAC-1 autopilot computers.
Used to increase or decrease the steering sensitivity. A low response level reduces the rudder
activity and provides a more loose steering. A high response level increases the rudder activity
and provides more tight steering. Too high a response level will cause the boat to make “S”
movements.
Autopilot | NSS evo2 Operator Manual
63
To Next Page
Loading...
Need help?
General
