EasyManuals Logo
Home>Simrad>Marine Equipment>NSS evo2

Simrad NSS evo2 User Manual

Simrad NSS evo2
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
Video
The video function allows you to view videos or camera sources on your system.
Ú
Note: The video images are not shared from the Ethernet network. You can only view
the video on the unit connected to the video source.
If a FLIR camera is available on the Ethernet network, you can display the video and control
the camera from the system.
For information about how to connect the camera, see the separate NSS evo2 Installation
manual.
The Video panel
A video panel can be set up as a single panel, or as one of the panels on a multiple panel
page.
The video image is proportionally scaled to fit into the video panel. Areas not covered by the
image are colored black.
Setting up the video panel
Video source
NSS evo2 supports two video input channels. You can select to view one channel only, or to
cycle the image between available video cameras.
The cycle period can be set from 5 to 120 seconds.
Video standard
NSS evo2 supports NTSC and PAL video. Check the local video standard or the standard of
your cameras.
Adjusting the video image
You can optimize the video display by adjusting the video image settings. The settings are
adjusted individually for each video source. Default for all settings: 50%.
FLIR camera control
When the connection is established to a FLIR camera, the menu changes to include access to
FLIR camera controls.
Ú
Note: You can take over camera control from other MFDs connected to the Ethernet
network.
Establishing connection with the FLIR video camera
When a video panel is active, the NSS evo2 automatically recognizes a FLIR camera if it is
available on the network.
Ú
Note: When there is a DHCP server present on the Ethernet network, the FLIR camera
needs to be configured and set to have a Static IP Address before the connection can be
established. For instructions on how to configure your specific FLIR camera model, refer
to FLIR documentation.
Ú
Note: Only one FLIR camera can be connected to the Ethernet network.
When you activate a video panel, the system starts searching the network for a FLIR camera.
19
Video| NSS evo2 Operator Manual
115

Table of Contents

Other manuals for Simrad NSS evo2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simrad NSS evo2 and is the answer not in the manual?

Simrad NSS evo2 Specifications

General IconGeneral
BrandSimrad
ModelNSS evo2
CategoryMarine Equipment
LanguageEnglish

Related product manuals