SINTERIT Lisa X - Page 54

Sinterit LISA X User Manual | 54
Fig. 12.57 Use PHS or Powder Separator with ATEX vacuum cleaner to clean the print chamber.
10. Press POSITION BED to begin the positioning process
of the Feed Bed and Recoater.
11. When the positioning is nished, the Feed Bed should
be at half its height and the Recoater above it.
12. Wipe the Recoater roller with dry cloth to remove the
powder (g. 12.58).
13. Next, wipe the Recoater roller using cloth soaked in
ethyl alcohol (g. 12.58). Press DONE.
%
Fig. 12.58 Use the cloth and ethyl alcohol to clean the Recoater
roller, when it is above the Feed Bed.
14. Press POSITION BED to begin the positioning process
of the Print Bed and Recoater.
15. When the positioning is nished, the Print Bed should
be at half its height and the Recoater above it.
16. Once again, wipe the Recoater roller with dry cloth to
remove the powder (g. 12.59).
17. Next, wipe the Recoater roller using cloth soaked in
ethyl alcohol (g. 12.59). Press DONE.
%
Fig. 12.59 Use cloth and ethyl alcohol to clean the Recoater roller,
when it is above the Print Bed.
18. Reinstall the black Recoater cover (g. 12.60).
19. Tighten the screws securing the black Recoater cover.
Use a 2 mm allen key.
20. Good job. The maintenance timer will reset to zero.
Fig. 12.60 Reinstall the black Recoater cover
and tighten the screws.