IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This symbol points out important safety instructions which, if not followed, could endanger
the personal safety and/or property of yourself and others. Read and follow all instructions
in this manual before attempting to operate your machine.
Failure to comply with these instructions may result in personal injury.
General Operation
• Read, understand, and follow all instructions in the manual and on the machine before
starting. Keep this manual in a safe place for further and regular reference and for ordering
replacement parts.
• Only allow responsible individuals familiar with the instructions to operate the machine. Be
sure to know controls and how to stop the machine quickly.
• Never put your hands near moving parts.
• Only allow qualified individuals for the maintenance of your machine.
• Remove all obstacles, which may interfere with the machine functions.
• Clear the work area such as electrical wires, buckets, knives etc.
• Be sure that everyone else is clear of your work area before operating the machine.
• Do not sit nor stand on the machine.
• Always turn off the machine after your work is done. Never leave a running machine
unattended.
• Always disconnect and wait till the machine has cooled before attempting any maintenance.
• Do not wear loose fitting clothes or jewelry as they may get caught in moving parts of the
machine.
• Always wear security shoes, to prevent injury caused by moving the machine or objects falling
from the machine.
• Never exceed the time limit to seal, which is recommended by the manufacturer. This is to
avoid any damage that may be caused to the sealing bars and to eliminate the risk of fire in
the machine. Thus avoiding corporal burns.
• Never touch the sealing bars after they have been used, this will avoid corporal burns. Wait a
few minutes to let the machine cool down before touching.
• Always make sure that the sealing bars are well installed in their "Guide Blocks" before
starting a cycle.
• Never incline the machine more than 30 degrees, it may tip over and hurt someone seriously.
• Work only in daylight or good artificial light.
Do not operate the machine while under the influence of alcohol or drugs!
To Next Page
Loading...