3.3 Vacuum packaging operation:
3.3 Vacuum packaging operation:
Note: Refer to the menus structure on page 14 and the keyboard detail on page 15.
3.3.1 Basics:
Use key "POWER" to power ON / OFF the vacuum packaging machine. When the unit
is energized, the identification of the last executed program is displayed on LCD screen.
Use the "ESC" key to change over from the programs menu to the functions menu and
from the functions menu to the programs menu.
In functions menu, use key "SELECT" to select a function and key "ENTER" to accede
and executed the selection.
In programs menu, use key "SELECT" to select a program and key "ENTER" to accede
and modify the selection.
In programs submenu, use key "ENTER" to pass over the parameters and point to the
following one; the parameters are blinking to point out the acquisition mode. A return to
programs menu is performed automatically following the last parameter acquisition.
In program submenu, use key "ESC" to get back to the programs menu.Strike any key
to clear the error messages which may be displayed on LCD screen.
3.3.2 Functions:
3.3.2.1 Create a program:
When executing the "create a program" function, the program submenu is
acceded, starting with the identification. The initial identification "Pxx NO NAME"
is given to the program and all parameters are established to zero; the program
number is allocated automatically.
3.3.2.2 Delete a program:
When executing the "delete a program" function, the programs menu is acceded
and the number of the first program in memory is blinking to point out the
deletion mode. Use key "SELECT" to select a program and key "ENTER" to
accede and confirm deletion of the selection. Use key "ESC" to unconfirm a
deletion and to leave the function. When leaving the function, the number of the
actual program on LCD screen cease to blink.
3.3.2.3 Select operating mode:
When executing the "select operating mode" function, which is available only for
the automatic units, the actual selection is blinking to point out the acquisition
mode. Use key "SELECT" to get through the operating modes, which are
automatic, semi-automatic and manual; the validation of the selected operating
mode is performed automatically. Use key "ESC" or "ENTER" to leave the
function and get back to the program menu.
To Next Page
Loading...