Page 10 of 92
Chapter: 2. Operation
Fig. 1.1 Operator unit, panel layout.
Screen Select
The screen select button facilitates selection of one of the 7 screen and softkey layouts. The 3 primary
operation screens (Screen Pilot, Screen Docking/Shallow Water and Screen Open Sea) may be cycled by
repeatedly pressing the SCREEN SELECT button. Access to the remaining 4 screens (Screen Com, Screen
Status, Screen Calibration and Screen Diagnostic) is done by pressing the “Screen select” and at the same
time turn the “encoder”.
Day/Night
Day/Night vision may be selected by pressing this button. These two modes diers by colour presentation,
which are optimized for dierent ambient light conditions.
Brightness
Backlight may be controlled by using the appropriate button and the encoder. Press the backlight button and
rotate the encoder until a satisfactory setting is obtained, then release the button. The settings are maintained
in the memory, and the last settings are restored on power up.
2. Operation
When the installation is complete, and power is connected to the operator unit, the system is switched on/o
by a power switch inside the cabinet.
To Next Page
Loading...
