Page 36 of 92
Chapter: 4. Installation
4. Installation
This chapter contains information related to installation of the Doppler speed log. Please ensure you
perform all the following subsections:
• Installation of bottom parts/transducer. See
• Operator unit installation, see “Operator Unit Installation” on page 37.
• Interfacing, see “Operator Unit - Connecting External Equipment” on page <?>.
• Selecting voltages, see “115/230 V selection on Combo Terminal board inside Display Unit” on
page 37.
• Connecting the transceiver unit. (See “Transducer Installation” on page 35).
• Checking (see “5. Start-up and system adaption” on page 35).
Handling warning
• The Doppler system is a sensitive measuring device, all parts must be handled carefully.
Please pay particular care with handling of the bottom parts and follow all instructions with
regards to handling and installation.
• The transducer is supplied with a foam packaging. Keep this in place until the sensor is placed
in the valve.
Standard System Supply
A basic Doppler system consists of the following units (see overview drawings in chapter “10.
Appendix 1” on page 35).
• Display/operator unit.
• Communication cable (if ordered, else yard supply).
• Transceiver unit.
• Sensor cable.
• Transducer (sensor).
• Bottom parts, usually a sea valve assembly.
•
Transducer Installation
For bottom part installation and placement, see separate manuals.
Additional manuals are available from your supplier (contact information on cover page).
To Next Page
Loading...
