Page 82 of 92
Chapter: 12. Appendix 3. Non wheelmark approved features
12. Appendix 3. Non wheelmark approved features
In this appendix we will describe the functions only enabled after 3 beeps (about 12sec) pressing the hidden
key. These features are non-approved features.
Echo sounder function
The echo sounder (ES) function on “screen Pilot” is disabled by default, and the control softkey (ES MODE)
on “screen Diagnostics”, “menu 3” is not available.
To enable the ES MODE soft key 3 (“screen Diagnostic, menu 3”), rst set the DETAILS soft key 2 in
screen Diagnostics menu 1 to “On”, then press the “hidden button” (inside the cabinet) and keep it pressed
for about 12 seconds (third beep must be heard while pressed). Now, the ES MODE soft key 3 in “screen
Diagnostics, menu 3” is visible. Default soft key 3 value is “O”, set to “On for activation of ES MODE. If
the same procedure is repeated once more, the ES softkey 3 will not be visible again. In this case the echo
sounder presentation will also be removed from the screen.
Note: The ES function must be disabled on screen diagnostics menu 3 before disabling the buttons.
ES MODE active in “screen Pilot
To Next Page
Loading...
