Page 86 of 92
Chapter: 13. Appendix 4. Non wheelmark approved S version
Current function
The current in water may be calculated by the dierence of STW (Speed through water) and SOG (Speed
over ground).
Please note! The current calculation is very depending on an exact sensor heading oset and speed
calibration.
To switch on current function:go to “Screen diagnostics#, “Menu 4”
The current function is visible by pressing “hidden button”and keep it pressed for about 12 seconds (third
beep must be heard while pressed).
Set “Current ON”
In “Screen pilot”, “Menu2” set “Sea current” to “Auto” The calculation of current will then be
automatically switch to SOG from GPS when bottom is lost.
Sea current will be graphically visible in “Screen pilot”.
To Next Page
Loading...
