Skipper DL850 - Back-Up Battery Jumper JP200

Edition: 2017-09-25
Page 39 of 92
Chapter: 4. Installation
Fig. 4.2 Static Memory Battery Jumper, I/O Board.
Back-up Battery Jumper JP200
The battery back up memory on I/O PCB is not in use from SW version 4.03.04 and up. Refer to Fig.
4.2 for the correct setting of the battery jumper “OFF” position 1-2.
This jumper should be set to the “ON” position 2-3 only on software version 4.03.03 or lower.
1.
3.
2.
Operation and Installation DL850 270 kHz
SKIPPER Electronics AS