Skipper DL850 - Operation Screens and Parameter Entry

Edition: 2017-09-25
Page 11 of 92
Chapter: 2. Operation
Parameter entry
The xed function buttons and the softkey buttons along with the rotating encoder, facilitates entry of
parameters and other data. The following owchart illustrates the procedure for changing settings. The
various screens are shown in detail in the operation section.
Primary Screens
Each of the operation screens contains a graphic picture and one or more menu sets congured on
the 6 softkey buttons. The three rst screens are covering the primary functions. Manoeuvring within
these screens are easily done by pressing the SCREEN SELECT button.
The various screens can also be selected by keeping the SCREEN SELECT button pressed and
rotating the encoder in either direction. Turning the encoder clockwise cycle the screens as shown in
gure below, and counter clockwise rotation cycles the screens in the opposite direction.
The screen layouts are outlined in the following pages. The various menus and softkey functions are
described with each screen.
PILOT OPEN SEA COM STATUS CALIB
2. System On/
o
1. Trip
2. Manual
calib
3. Oset
4. Pulse
settings
3. Boat setup/
Buzzer
5. Analogue
settings
8. Speed test/
Demo
2. COM setup
1. Units
1. System On/
o
1. NMEA setup
2. Date/Time
1. Auto calib
*
*
1. Docking
views
SHALLOW/
DOCKING
Primary Screens
*
Symbol Description
Normal route using SCREEN SELECT
button.
- - - - - - - Use SCREEN SELECT button and encoder
to get past “barrier” and get access to
screen COM, STATUS, CALIB, and
DIAGNOSTICS.
* Use “hidden” button on keyboard to enable
options.
Barrier
Note: Use SCREEN SELECT button
and the encoder to pass the barrier.
DIAGNOSTICS
1. Self
diagnostics
On/o
**
6. Speed limit/
Hysteresis
Barrier
7. Signal good/
Suspected
2. Filter
*
3. Settings
Barrier
4. Settings
4. Mounting
settings
Operation and Installation DL850 270 kHz
SKIPPER Electronics AS