Skipper DL850 - Screen Com, Menu 1, NMEA Setup

Edition: 2017-09-25
Page 20 of 92
Chapter: 2. Operation
Note: The displayed messages corresponds to currently selected port.
Screen com, Menu 1, NMEA setup.
Softkey Name Range/value Default
value
Description Activate
with hidden
button
1 MENU 1-2 1 Menu 1 is selected.
2 COM 1-2 1 Select COM port. The ports can be congured to
give dierent messages on the dierent ports.
3 RESET
COM
ERROR
Reset Reset of Data error counter. The program
memorizes the latest occurred NMEA input error
for further analysis. By using this softkey, it is
possible to reset the error.
4 MESSAGE DPT, DBT, DBK,
VTG, VHW, VLW,
VLW IEC07, VBW,
MTW, STA, VDR
NMEA message selector. Each message may be
controlled individually by softkey 5. (Note: See ""
on page 48).
5 OUTPUT On/O See g
above.
Setting for the message in softkey 4. Note: To
congure the serial output of the system, go
through all the messages by pressing softkey 4 and
set on/o value with softkey 5 to disable/enable a
message as required.
Yes (1 beep)
6
DISPLAY Output/input/o Input Selects the information (received from the
external source or transmitted by the DL850) to be
displayed on the screen.
Output: Signals transmitted from DL850.
Input: Signals received from external source.
O: No signals displayed on screen.
SKIPPER Electronics AS
Operation and Installation DL850 270 kHz