Page 66 of 92
Chapter: 6. Trouble Shooting
Master reset: Press down these two softkeys and keep them
pressed during the “power-up” sequence.
Reset factory procedure.
In some cases the display cabinet may get “confused”, or the user has “adjusted” too much. Performing a
“reset factory” procedure will return all values to factory default settings.
The “Reset factory” will not reset calibration, I/O settings (NMEA) or total trip.
• To perform “reset factory”, See”RESET FACTORY” on page 26
Master reset procedure.
If “reset factory” did not help performing a master reset procedure will return all values to factory default
settings.
Important note: Before performing this, note your calibration settings, and setup for inputs and outputs as
these will be lost during this procedure.
• Switch o the display unit using the internal toggle switch(es) and wait a few seconds.
• Then press down and keep pressed the softkey to the far right and far left (no. 1 and 6) in the upper row
on the keyboard (softkeys).
• Turn “on” the display unit, and keep the two softkeys pressed down until the screen shows the normal
picture. This may take as long as app. 30 seconds.
• You should now normally hear 4 ‘’beeps’’.
Note: You will now have to re-apply your settings for calibration, input/output and screen settings
To Next Page
Loading...
