Skipper DL850 - Setup and Function Control Screens

Edition: 2017-09-25
Page 18 of 92
Chapter: 2. Operation
Setup and Function Control Screens
Each of the operation screens contains a graphic picture and one or more menu sets congured on the
6 softkey buttons. Manoeuvre to the setup and function control screens by keeping the screen select
button pressed and rotating the encoder in either direction. Turning the encoder clockwise cycle the
screens as shown in gure below, and counter clockwise rotation cycles the screens in the opposite
direction.
The screen layouts are outlined in the following pages. The various menus and softkey functions are
described with each screen.
PILOT OPEN SEA
COM STATUS CALIB
2. System On/
o
1. Trip/Speeda-
larm
2. Manual
Calibration
3. Oset
4. Pulse
settings
3. Boat setup/
Buzzer
5. Analogue
settings
8. Speed test/
Demo
2. COM setup
1. Units1. System On/o 1. NMEA setup
2. Date/Time
1. Auto
Calibration
*
*
1. Docking
views
SHALLOW/
DOCKING
Setup and Function Control Screens
*
Barrier
Barrier
DIAGNOSTICS
1. On/o
6. Speed limits/
Hysteresis
Note: Use SCREEN SELECT button
and the encoder to pass the barrier.
Symbol Description
Normal route using SCREEN SELECT
button.
- - - - - - - Use SCREEN SELECT button and
encoder to get past “barrier” and get
access to screen PILOT, SHALLOW
WATER/DOCKING and OPEN SEA.
* Use “hidden” button on keyboard to
enable options.
7. Signal good/
Suspected
2. Filter
*
3. Settings
Barrier
4. Settings
4. Mounting
settings
SKIPPER Electronics AS
Operation and Installation DL850 270 kHz